Building and running the `wave` example on orcinus

Commands that you will need to type are in bold. It is also assumed that DV is running on your local workstation, and that in your orcinus shell you have set DVHOST to the name of said workstation, e.g.

% setenv DVHOST bh0.phas.ubc.ca

Change to a convenient working directory (perhaps your home) and copy the example from Matt's templates directory:

% cp -a ~matt/templates/pamr-wave .

Change to pamr-wave, and ensure that the proper compilation environment is set up (source command)

% cd pamr-wave
% source ~matt/scripts/soINTEL-mpi-orc
MPI_HOME=/global/software/openmpi-1.4.3/intel/
       .
       .
       .
CC = /global/software/openmpi-1.4.3/intel//bin/mpicc
LDFLAGS = -O3 ...

Make the application

% make

Submit the batch job

% qsub pamr-wave.pbs

Wait for the batch job to finish: you can use qstat -u $LOGNAME command to monitor the status of your job, but you can tell when the job has completed by the appearance of the standard output and standard error files associated with the run. These will have names of the form pamr-wave.o[Job id] and pamr-wave.e[Job id] where [Job id] is the numeric part of the Job id which is returned by the qsub command.

Once the run has completed, the directory should contain 8 .sdf files, one for each of the 8 processors that were used in the sample computation.

% cd run_2d
% ls *sdf
wave_2d_L0_phi_tl2_0.sdf  wave_2d_L0_phi_tl2_3.sdf  wave_2d_L0_phi_tl2_6.sdf
wave_2d_L0_phi_tl2_1.sdf  wave_2d_L0_phi_tl2_4.sdf  wave_2d_L0_phi_tl2_7.sdf
wave_2d_L0_phi_tl2_2.sdf  wave_2d_L0_phi_tl2_5.sdf

Send all of these to DV using sdftodv:

% sdftodv *sdf

Then select Merge -> All Registers in DV, enable AMR in the Options panel, and visualize the results.

You can use Makefile and pamr-wave.pbs as templates for your own application.

Maintained by [email protected]. Supported by CIAR, CFI and NSERC

Building and running the wave example on orcinus

Building and running the `wave` example on orcinus